P0139 Oxygen Sensor Circuit Slow Response (B1S2)
Technical Description
Oxygen Sensor Circuit Slow Response (Bank1, Sensor2)
What does that mean?
This diagnostic trouble code (DTC) is a generic powertrain code, which means that it applies to OBD-II equipped vehicles. Although generic, the specific repair steps may vary depending on make/model.
This involves the rear oxygen sensor on the driver's side. This code indicates the engine air fuel ratio is not being adjusted by the oxygen sensor signal or the ECM as expected to do so, or not adjusted as often as expected to do so once the engine is warmed or under normal engine use. Bank 1 is the is the bank of cylinders that contains cylinder #1.
Symptoms
You will likely not notice any drivability problems, although there may be symptoms.
Causes
A code P0139 may mean that one or more of the following has happened:
The oxygen sensor is faulty The wiring to the sensor is broken / frayed There is an exhaust leakPossible Solutions
The simplest thing to do is to reset the code and see if it comes back.
If the code comes back, the problem is more than likely the rear driver's side oxygen sensor. You will likely wind up replacing it but you should also consider these possible solutions:
Check and fix any exhaust leaks Check for wiring problems (shorted, frayed wires) Check the frequency and amplitude of the oxygen sensor (advanced) Check for a deteriorating / contaminated oxygen sensor, replace if necessary Check for inlet air leaks Check the MAF sensor for proper operationRead: 47
