P0882 TCM Power Input Signal Low Trouble Code

P0882 TCM Power Input Signal Low

OBD-II Trouble Code Technical Description

TCM Power Input Signal Low

What does P0882 mean?

This diagnostic trouble code (DTC) is a generic powertrain code and applies to many OBD-II vehicles (1996-newer). That may include but is not limited to vehicles from Hyundai, Allison, Range Rover, BMW, Chevy, Kia, Dodge, Jeep, etc. Although generic, the exact repair steps may vary depending on year, make, model and powertrain configuration.

 

If your vehicle has stored a code P0882, accompanied by a malfunction indicator lamp (MIL) and/or a TCM (transmission control module) lamp, it means that the powertrain control module (PCM) has detected a low voltage condition in the TCM power input circuit.

While some transmission control modules (for OBD-II equipped vehicles) are integrated into the PCM, most are stand-alone components. TCM related codes are stored as P-codes, B-codes, or even U-codes, depending on vehicle make and model. If a P0882 code is stored, there is a good chance that there are other PCM and/or TCM codes stored as well. Antilock braking system (ABS) codes may be stored, as well.

Electronic transmission control systems in OBD-II equipped vehicles are controlled using a network of computers (called control modules). This involves constant communication between the various control modules via the controller area network (CAN).

The CAN is a complex system of wiring and connectors that is utilized to transmit data between the TCM and the PCM. Data (including stored codes) may also be shared with other controllers via the CAN. Transmission input and output speed (RPM), vehicle speed, and wheel speed are all shared between multiple controllers. This data is not only used for comparison in electronic traction control systems, but anti-lock braking systems and electronic stability control systems as well.

The PCM utilizes input signals from multiple engine and transmission sensors to calculate automatic transmission shift strategy. A high-pressure pump (inside the transmission) forces fluid through the valve body and into the sprag assembly; in addition to lubricating and cooling the transmission. The high-pressure fluid allows the clutches to separate from the sprag momentarily so that the gear ratio may be changed smoothly. One or more electronic pressure control (EPC) solenoids help to regulate fluid pressure. Electronic pressure (EP) sensors provide the PCM with pertinent data regarding fluid pressure at various points in the transmission. Electronic shift solenoids are used to interrupt the flow of high-pressure fluid so that the transmission shifts gears when commanded. The PCM uses voltage input signals from the transmission input speed sensor and transmission output speed sensor to determine if the transmission is shifting efficiently.

As with many other automatic transmission malfunctions, a transmission control system code may be caused by either an electrical or mechanical failure. If the PCM detects a malfunction, MIL illumination should occur and a code P0882 will be stored.

An example of a typical TCM transmission control module:

What is the severity of this DTC?

If this code is stored, you may have noticed that your transmission shifts much more harshly than normal. If your vehicle has exhibited a code P0882 , it should be diagnosed as soon as possible.

What are some of the symptoms of the code?

Symptoms of a P0882 trouble code may include:

Electronic traction control disabled Erratic transmission shift patterns Failure of the transmission to shift Other related codes ABS disabled

What are some of the common causes of the code?

Causes for this code may include:

Bad relay or blown fuse (fusible link) Vehicle speed sensor failure Open or shorted circuits in the CAN Mechanical transmission failure Defective TCM, PCM, or programming

_{Read: 23}