P0602 Control Module Programming Error Trouble Code

P0602 Control Module Programming Error

OBD-II Trouble Code Technical Description

Control Module Programming Error

What does that mean?

This diagnostic trouble code (DTC) is a generic powertrain code, which means that it applies to OBD-II equipped vehicles (Dodge Ram Cummins, Chevy GMC Duramax, Isuzu, Volvo, Vauxhall, VW, etc.). Although generic, the specific repair steps may vary depending on make/model.

Photo of a PCM with the cover removed:

If your OBD II equipped vehicle has stored a code P0602, it means that the powertrain control module (PCM) has detected an internal programming error. The programming error applies to the PCM itself.

 

When you look at a PCM, you may only see a metal box but it is what’s inside that is essential to efficient engine operation. Information that is vital to engine management is programmed from the factory using the electronically erasable programmable read only memory (EEPROM).

Vehicle specific settings for engine and transmission management are programmed into the EEPROM for each vehicle that leaves the factory. The EEPROM not only helps to manage engine efficiency and performance but also serves to recognize and interact with other onboard vehicle control modules.

If the PCM detects inconsistencies with the EEPROM, or if it fails to recognize the program of the EEPROM, a code P0602 will be stored and a malfunction indicator lamp (MIL) may be illuminated. Depending upon the severity of the malfunction, multiple ignition cycles (with a malfunction) may be necessary for MIL illumination.

Other internal control module error trouble codes include:

P0601 Internal Control Module Memory Check Sum Error P0603 Internal Control Module Keep Alive Memory (KAM) Error P0604 Internal Control Module Random Access Memory (RAM) Error P0605 Internal Control Module Read Only Memory (ROM) Error

Code Severity & Symptoms

A stored code P0602 should be categorized as severe because conditions that caused it to be stored may affect engine management in a major way.

Symptoms of a P0602 code may include:

No start condition Multiple drivability issues Harsh or erratic automatic transmission shifting Diminished fuel efficiency The engine may stall or idle roughly

Causes

Possible causes for this code include:

PCM programming error New or incorrect PCM Aftermarket (high-performance) PCM program installed Blown ECM/PCM fuse Bad ECM/PCM power supply relay A defective ECM/PCM Open or shorted wiring or connectors in the CAN harness Insecure control module ground strap or broken ground wire

Diagnostic and Repair Procedures

Diagnosing a code P0602 can be challenging, even to the most experienced and well equipped technician. Nevertheless, there are a few preliminary tests that can be performed before throwing your hands in the air and passing the problem off to someone else.

As usual, I would begin my diagnosis with a visual inspection of engine management wiring harnesses and connectors. Any wiring and connectors that have been damaged or burned should be repaired or replaced. Next, I would connect the scanner to the vehicle diagnostic connector and retrieve all stored codes and freeze frame data. Before clearing the codes, I would write them down just in case this proves to be an intermittent code. A code P0602 must be diagnosed and repaired before diagnosing and repairing any other stored codes, as other stored codes are likely to be false. Now clear the codes in the hope that the P0602 has been stored in error.

If the P0602 is immediately reset, check for battery voltage to the PCM. The PCM requires battery voltage to function properly. If the battery terminals are corroded or loose, there may be inadequate voltage reaching the PCM. Check PCM relays and fuses for battery voltage with the circuit loaded. Corroded fuses may appear normal until a lo

_{Read: 40}