P047E Exhaust Pressure Sensor "B" Circuit Intermittent/Erratic Trouble Code

P047E Exhaust Pressure Sensor Circuit B Intermittent

OBD-II Trouble Code Technical Description

Exhaust Pressure Sensor Circuit "B" Intermittent/Erratic

What does that mean?

This generic powertrain/engine diagnostic trouble code applies to all engines that use variable nozzle turbochargers (gas or diesel), starting around 2005 on Ford trucks equipped with 6.0L diesel engines, all Ford EcoBoost engines, and eventually leading to the Cummins 6.7L in 2007, the 3.0L in the Mercedes lineup in 2007 and here recently the Cummins 3.0L 6 cyl in the Nissan pickups starting in 2015. That's not to say you wouldn't necessarily get this code in a VW or other make though.

 

This code is strictly concerned about the incoming signal from the exhaust pressure sensor not matching intake manifold pressure or ambient air pressure at various times during engine operation. This can be an electrical circuit fault or it can be mechanical.

Codes P047B, P047C or P047D may also be present at the same time as the P047E. The only difference between these codes is how long the problem lasts and the type of electrical / mechanical problem that the sensor/circuit/engine controller is having.

Troubleshooting steps may vary depending upon manufacturer, gas or diesel, type of exhaust pressure sensor and wire colors. Refer to a vehicle specific repair guide to determine which is the "B" sensor for your particular vehicle.

A typical exhaust pressure sensor:

Related exhaust pressure sensor "B" trouble codes:

P047A Exhaust Pressure Sensor "B" Circuit P047B Exhaust Pressure Sensor "B" Circuit Range/Performance P047C Exhaust Pressure Sensor "B" Circuit Low P047D Exhaust Pressure Sensor "B" Circuit High

Symptoms

Symptoms of a P047E engine code may include:

Check Engine Light illuminated Lack of power Unable to perform manual regeneration – burn off the soot out of the particulate filter. Looks like a catalytic converter but has temp sensors and pressure sensor probes inserted into it. If unable to perform regeneration, eventually may become a crank-no start.

Potential Causes

Typically the causes for this code to set are:

Blockage in the tube from the exhaust manifold to the pressure sensor Exhaust Gas Recirculation system / Air Inlet / Charge Air leaks Intermittent open in the ground circuit to the exhaust pressure sensor Intermittent open in the signal circuit between the exhaust pressure sensor and the PCM Intermittent short to voltage in the signal circuit to the exhaust pressure sensor Exhaust Gas Pressure Sensor Possibly a powertrain control module (PCM) has failed (highly unlikely)

Diagnostic and Repair Procedures

A good starting point is always a technical service bulletin (TSB) search for your particular vehicle. The vehicle manufacturer may have a PCM flash/reprogram to cover this issue, and it pays to check on this before you find you’ve gone down a long/wrong path.

Next, locate the Exhaust Pressure Sensor on your particular vehicle. Once located, disconnect the tube that connects the sensor to the exhaust manifold. Attempt to blow through it. If unable to, try to run a small piece of wire through it to dislodge the carbon that is trapped inside, causing the fault code you are encountering.

If the tube is clear and free, visually inspect the connectors and wiring. Look for chafing, rubbing, bare wires, burn spots or melted plastic. Pull the connectors apart and carefully inspect the terminals (the metal parts) inside the connectors. See if they look corroded, burnt or possibly green in color versus the normal metal color you are probably used to seeing. You can get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed. If this is not possible, find some 91% rubbing alcohol and a

_{Read: 44}