P069E Fuel Pump Control Module Requested MIL Illumination
OBD-II Trouble Code Technical Description
Fuel Pump Control Module Requested MIL Illumination
What does that mean?
This is a generic diagnostic trouble code (DTC) and applies to many OBD-II vehicles (1996-newer). That may include but is not limited to vehicles from GMC, Chevy, Buick, Cadillac, Ford, etc. Although generic, the exact repair steps may vary depending on year, make, model, and powertrain configuration.
A stored code P069E means that the powertrain control module (PCM) has detected a malfunction with the fuel pump control module so that it has requested malfunction indicator lamp (MIL) illumination.
The fuel pump control module is responsible for supply and regulation of voltage to the fuel pump relay and the fuel pump. Typically, the fuel pump controller is integrated into the PCM but it may also be a stand-alone module. The fuel pump provides pressurized fuel for the fuel injection system. It is most often located inside the fuel tank but may also be along the fuel rail. Diesel propulsion systems most often use high pressure pumps that are mounted on and driven by the engine.
Each time the ignition is turned on (and the PCM is energized), multiple controller self-tests are performed. The fuel pump control module is included in these controllers. By performing internal controller self-tests, the PCM can monitor serial data that is carried over the controller area network (CAN) to ensure that on-board controllers are interfacing properly.
If the fuel pump control module has requested that the MIL be illuminated, a code P069E will be stored and a malfunction indicator lamp (MIL) may be illuminated.
Photo of a typical fuel pump control module:
What is the severity of this DTC?
Fuel pump control module codes should always be taken seriously. The conditions which cause a code P069E to be stored could result in numerous drivability issues and/or a no-start condition.
What are some of the symptoms of the code?
Symptoms of a P069E trouble code may include:
Delayed engine starting No-start condition Engine drivability issues Other stored codesWhat are some of the common causes of the code?
Causes for this code may include:
Faulty fuel pump controller or PCM Open fuel pump control module voltage supply circuit Bad or tripped fuel pump voltage shutoff (inertia) switch PCM failure or PCM programming errorWhat are some P069E troubleshooting steps?
If other fuel pump and/or fuel supply codes are stored, diagnose and repair those before attempting to diagnose the code P069E.
Consult your vehicle information source for technical service bulletins (TSB) that replicate the code stored, vehicle (year, make, model, and engine), and symptoms exhibited. If you find the appropriate TSB, it may yield helpful diagnostic information.
A diagnostic scanner, a digital volt/ohmmeter (DVOM), and a source of reliable vehicle information will be required to diagnose a code P069E.
Begin by connecting the scanner to the vehicle diagnostic port and retrieving all stored codes and freeze frame data. You will want to write this information down, just in case the code proves to be an intermittent one. After recording all pertinent information, clear the codes and test drive the vehicle (if possible) until the code is reset or the PCM enters readiness mode.
If the PCM enters readiness mode, the code is intermittent and will be more difficult to diagnose. The condition, which caused the P069E to be stored, may need to worsen before an accurate diagnosis can be reached. If the code is reset, continue with your diagnosis.
Use your source of vehicle information to obtain connector face views, connector pin-out charts, component locators, wiring diagrams, and diagnostic flow charts related to the code and vehi
Read: 33
