P215C Output Shaft Speed - Wheel Speed Correlation Trouble Code

P215C Output Shaft Speed - Wheel Speed Correlation

OBD-II Trouble Code Technical Description

Output Shaft Speed - Wheel Speed Correlation

What does that mean?

This is a generic diagnostic trouble code (DTC) and typically applies to OBD-II vehicles. Vehicle makes may include but aren't limited to Jeep, Chrysler, Dodge, Chevy, etc.

 

If your OBD-II equipped vehicle has stored a code P215C, it means that the powertrain control module (PCM) has detected a discrepancy between the vehicle output shaft speed sensor and one (or more) of the wheel speed sensors.

The output shaft speed sensor and the wheel speed sensor are both intended to detect vehicle speed but each is a component of a separate network. The output shaft speed sensor is part of the powertrain control network and the wheel speed sensor is part of the antilock brake system network.

The output shaft speed sensor is an electromagnetic sensor which is mounted in close proximity to some type of toothed reluctor ring wheel or gear. The reluctor ring is mechanically affixed to an axle, transmission/transfer case output shaft, or driveshaft. The reluctor ring spins in conjunction with the axle. As the reluctor ring teeth pass within thousandths-of-an-inch of the output shaft speed sensor, the magnetic field completes the output shaft speed sensor input circuit. The notches between the reluctor ring teeth create interruptions in the same circuit. These completions/interruptions occur in rapid succession as the vehicle rolls forward. These circuit completions and interruptions create wave form patterns that are received by the PCM (and other controllers) as output shaft speed. As wave form pattern speed increases, estimated output shaft speed increases. Likewise, as the input speed of the wave form slows, estimated output shaft speed decreases.

In much the same way as the PCM monitors output shaft speed, the antilock brake control module (ABCM) monitors input data from the wheel speed sensors. Wheel speed sensors are mounted near a reluctor ring on a brake rotor, hub assembly, or differential ring gear. Most OBD-II vehicles are equipped with a four-wheel antilock brake system (ABS) but some applications have a rear-wheel only antilock braking system.

Independent rear axle vehicles with four-wheel ABS have four wheel speed sensors Fixed rear axle vehicles with four-wheel ABS will incorporate three sensors Vehicles with an independent rear axle and rear-wheel ABS may have two sensors Vehicles with a fixed rear axle and a rear-wheel ABS system will have just one wheel speed sensor

The PCM is constantly monitoring output shaft speed when the vehicle in moving forward. Individual wheel speed sensor inputs are constantly monitored by the ABCM or electronic brake control module (EBCRM). The two controllers share data via the CAN and compare the signals anytime the vehicle is in motion. If either of the controllers detects a variation between output shaft speed and wheel speed that exceeds the maximum threshold (for a set amount of time) a code P215C will be stored and a malfunction indicator lamp (MIL) may be illuminated.

A wheel / ABS speed sensor:

What is the severity of this DTC?

The conditions which contribute to a code P215C being stored may result in ABS deactivation or erratic transmission shifting patterns. The code should be considered severe and addressed as quickly as possible. 

What are some of the symptoms of the code?

Symptoms of a P215C diagnostic code may include:

Erratic speedometer Inadvertent ABS or traction control system (TCS) activation Irregular transmission shift patterns ABS codes may be stored The ABS may be disabled

What are some of the common causes of the code?

Causes for this P215C code may include:

Excessive metallic debris on output/wheel speed sensor magnet Defective output shaft/wheel speed sens

_{Read: 23}