P025C Fuel Pump Module Control Low
OBD-II Trouble Code Technical Description
Fuel Pump Module Control Low
What does that mean?
This generic powertrain diagnostic trouble code (DTC) typically applies to all OBD-II vehicles equipped with a fuel pump control module. That may include but is not limited to vehicles from Ford, Chevrolet, Dodge, Chrysler, Audi, VW, Mazda, etc.
In older systems, vehicles required very little fuel pressure . These days on the other hand, with the invention of fuel injection and other systems, our vehicles require higher fuel pressures.
The Engine Control Module (ECM) meets our fuel needs by relying on the Fuel Pump Module to regulate pressures within the fuel system. The fuel pump itself, is responsible for delivering the fuel to the engine.
A failure here is most likely extremely evident as your car may not even start. The 3 main things an internal combustion engine needs to run is : Air, Fuel and Spark. Anyone of these missing and your engine will not operate.
The ECM activates P025C and associated codes when it monitors one or multiples conditions outside a specific electrical range within the Fuel Pump Control Module or it's circuit. This can be caused by either a mechanical or an electrical problem. Working with/around such a volatile substance makes it somewhat dangerous to diagnose or repair anything here so make sure you are properly trained and are familiar with the hazards involved.
P025C Fuel Pump Module Control Low code is set when the ECM monitors a lower than desired specific electrical value within the Fuel Pump Module or it's circuit(s). It is one of four related codes, which are P025A, P025B, P025C, and P025D.
What is the severity of this DTC?
I would say the severity of this code would be determined by your symptoms. If your car does not start, this would be severe. On the other hand, if your vehicle is operating normally and fuel mileage isn't being affected and this code is active, this isn't a very severe situation. That being said, neglecting any fault may result in further time and costs.
An example of a fuel pump control module:
What are some of the symptoms of the code?
Symptoms of a P025C trouble code may include:
Engine will not start Hard start Engine stalling Poor fuel mileage Inaccurate fuel level Fuel smell Poor engine performanceWhat are some of the common causes of the code?
Causes for this code may include:
Defective Fuel Pump Module Defective Fuel Pump Debris in Fuel Pump screen Wiring Issue (i.e.: frayed wire, melted, cut/open etc.) Connector problem (i.e.: melted, disconnected, intermittent connections etc.) ECM problemWhat are some P025C troubleshooting steps?
Be sure to check for technical service bulletins (TSBs) for your vehicle. Getting access to a known fix can save you time and money during diagnosis.
Tools
Some of the things you may need when diagnosing or repairing the fuel pump circuits and systems:
OBD code reader Multimeter Basic socket set Basic ratchet and wrench sets Basic screwdriver set Battery terminal cleaner Service manualSafety Tips
Let engine cool Chalk wheels Wear PPE (Personal protective equipment)NOTE: ALWAYS verify and record the integrity of your battery and charging system before further troubleshooting.
Basic Step #1
If your car does not start, there is one very easy backyard diagnosing approach. If your vehicle is equipped with a fuel pump mounted inside the fuel tank, you could give the tank a hit with a rubber mallet to potentially dislodge debris out of the pump while someone tries to start the vehicle. If your vehicle fires up when you do this, your diagnosing is complete, you need to replace the fuel pump itself.
NOTE: Whenever diagnosing/repairing anything involving the fuel system, make sure there are no
Read: 44
