P050E Cold Start Engine Exhaust Temperature Too Low
OBD-II Trouble Code Technical Description
Cold Start Engine Exhaust Temperature Too Low
What does that mean?
This generic powertrain diagnostic trouble code (DTC) typically applies to many OBD-II vehicles. That may include but is not limited to vehicles from Ford (Mustang, Escape, EcoBoost, etc.), Dodge, Jeep, Land Rover, Nissan, VW, etc.
When a code P050E is stored, it means that the powertrain control module (PCM) has detected an exhaust temperature that is below the minimum threshold, at cold start. Cold start is a term used to describe a drivability strategy used only when the engine is at (or below) ambient temperature.
In my professional experience, exhaust temperature is monitored only in vehicles equipped with clean burning diesel propulsion systems.
This code is more common in geographic locations with extremely cold climates.
Changes in exhaust temperature are critical to emission reduction in today’s clean burning diesel engines. The PCM must monitor exhaust temperature in order to ensure that the desired action is being taken to accomplish these drastic changes in temperature.
Diesel exhaust fluid (DEF) injection systems are responsible for the introduction of DEF into the catalytic converter and other areas of the exhaust system. These DEF mixtures initiate the increased exhaust temperatures required to burn harmful hydrocarbons and nitrogen dioxide particles trapped within the exhaust system. The DEF injection system is controlled by the PCM.
During engine cold start, exhaust temperature should be at or near ambient temperature. IF the PCM detects that exhaust temperature is lower than ambient temperature, a code P050E will be stored and a malfunction indicator lamp (MIL) may be illuminated. In most cases, multiple failures will be required for MIL illumination.
Cold car:
What is the severity of this DTC?
When a code P050E is stored, DEF injection is likely to be disabled. This code should be categorized as severe and rectified with urgency.
What are some of the symptoms of the code?
Symptoms of a P050E engine code may include:
Diminished engine performance Decreased fuel efficiency Excessive black smoke from the exhaust Accompanying DEF codesWhat are some of the common causes of the code?
Causes for this code may include:
Defective exhaust temperature sensor Burnt or damaged exhaust temperature sensor wiring Moisture trapped inside the exhaust has frozen PCM or PCM programming errorWhat are some P050E troubleshooting steps?
I would likely begin my diagnosis with a search for applicable technical service bulletins (TSB). If I can find one that matches the vehicle I am working with, the symptoms exhibited, and the codes that are stored, chances are that it will help me to diagnose the P055E accurately and quickly.
I will need a diagnostic scanner, an infrared thermometer with a laser pointer, a digital volt/ohmmeter (DVOM), and a reliable source of vehicle information to diagnose this code.
The vehicle information source will provide me with diagnostic flow charts for the P055E, wiring diagrams, connector face views, connector pin-out charts, and component testing procedures/specifications. This information will be instrumental in arriving at an accurate diagnosis.
After a visual inspection of exhaust temperature sensor wiring and connectors (with a focus on wiring that is routed near high-temperature areas), I would connect the scanner to the vehicle diagnostic port and retrieve all stored codes and pertinent data. Code data from the scanner may be helpful later in my diagnosis. I would write it down and keep in a safe place. Now, I would clear the codes and test-drive the vehicle (at cold start) to see if the code is reset. The test-drive should also displace a
Read: 41
