P0298 Engine Oil Over Temperature Condition
OBD-II Trouble Code Technical Description
Engine Oil Over Temperature Condition
What does that mean?
This diagnostic trouble code (DTC) is a generic powertrain code, which means it applies to most OBD-II equipped vehicles including but not limited to Ford, Nissan, Suzuki, Dodge, Chevrolet, Jeep, Subaru, etc. Although generic, the exact repair steps may vary depending on make/model.
A stored code P0298 indicates that the powertrain control module (PCM) has detected an engine oil temperature that is higher than acceptable. The conditions which contribute to a code of this nature being stored may be electrical or mechanical.
Not every vehicle is equipped with a system that monitors oil temperature. Personally, I have only encountered oil temperature monitoring systems on diesel applications. Engine oil temperature sensors are typically negative coefficient thermistors which decrease circuit resistance as oil temperature is elevated. The oil temperature monitoring circuit begins with a reference voltage signal (usually 5-volts), applied to the sensor. When engine oil is at or near ambient temperature, oil temperature sensor resistance is high and that keeps oil temperature sensor circuit voltage low (normally near .5-volts).
As oil temperature increases, and sensor resistance decreases, circuit voltage becomes greater. The PCM is programmed to recognize these variations in sensor circuit voltage as varying degrees of oil temperature. In some cases, the engine oil temperature sensor also provides an engine oil temperature gauge with an electrical signal that is displayed on the instrument panel for driver convenience.
If the PCM detects a level of engine oil temperature sensor circuit voltage that is not within the programmed parameters, a code P0298 will be stored and a malfunction indicator lamp may be illuminated.
A typical engine oil temperature sensor:
This code belongs in the P0200-P02FF batch of diagnostic codes. Related engine oil temperature sensor codes include P0195, P0196, P0197, P0198, and P0199.
Code Severity & Symptoms
A stored code P0298 should be considered urgent and diagnosed as soon as possible. The engine should not be operated until the conditions for causing this code to be stored are rectified.
Symptoms of a P0298 engine code may include:
Unusual engine noises and/or smells Engine coolant leaks Diminished engine performance Engine cooling system codesCauses
Possible causes for this P0298 code may include:
An engine cooling system condition that has resulted in engine overheating Defective engine oil temperature sensor Open or shorted circuit Corroded wiring and/or connectors Low oil levelDiagnostic and Repair Procedures
Before attempting to diagnose a code P0298, I would need a diagnostic scanner, a digital volt/ohmmeter (DVOM), and a reliable vehicle information source. While it is always a good idea to visually inspect system wiring and connectors prior to beginning your diagnosis in this case, it is most important that you make sure that the engine is full (to the appropriate limit and with the correct type) of good quality oil and engine coolant.
A note about overheating
Engine overheating is the leading cause of oil over temp conditions. Engine overheating may be the result of a coolant leak, a bad thermostat, cylinder head (or gasket) malfunctions, or an air flow problem. Make sure that the engine cooling system is filled with coolant and that all of the fans are operating as intended. If the engine cooling system is more than a half-gallon low, locate the source of the coolant leak and repair it.
With the engine cooling system filled with the proper coolant and working normally and the crankcase properly filled with oil, connect the scanner to the vehicle diagnostic conn
Read: 47
