P0084 Exhaust Valve Control Solenoid Circuit B2
OBD-II Trouble Code Technical Description
Exhaust Valve Control Solenoid Circuit (Bank 2)
What does that mean?
This code is a generic OBD-II powertrain code, that means it applies to all makes and models of vehicles (1996-newer), although specific repair steps may vary depending on the model.
On vehicles equipped with variable valve timing (VVT), the Engine Control Module / Powertrain Control Module (ECM/PCM) controls the camshaft position by regulating the engine oil through the control solenoid to change the position of the camshaft. The control solenoid is commanded using a Pulse Width Modulated signal (PWM) from the ECM/PCM. The ECM/PCM monitors this signal and if the voltage is out of specification or intermittent, it will set this DTC and illuminate the Check Engine Light / Malfunction Indicator Lamp (CEL/MIL).
Bank 2 refers to the side of the engine that does not contain cylinder #1 - be sure to verify according to manufacturers specifications. The exhaust valve control solenoid is usually located on the exhaust manifold side of the cylinder head. This code is similar to codes P0085 and P0086. This code may also be accompanied by P0029.
Symptoms
Symptoms may include:
Check engine light illuminated (Malfunction indicator lamp) Vehicle may suffer from poor acceleration and decreased fuel economy.Potential Causes
Potential causes of a P0084 trouble code may include:
Wire harness poor connection or corroded terminals Faulty control solenoid Short to power Short to ground Faulty ECMDiagnostic Steps
Wire harness - Check for unplugged harness connections, look for corrosion or loose wires to connectors. Unplug harness connectors from Solenoid and PCM, using a wiring diagram locate the + and - wires to the solenoid. The solenoid can be ground side or power side controlled, depending on the application. Check with factory wiring diagrams to determine the power flow in the circuit. Using a digital volt ohm meter (DVOM) set to the ohms setting, check for resistance between each end of the wire. An over limit reading on the DVOM may be an open in the wiring, loose connection or terminal. Resistance should be around 1 ohm or less, if there is excessive resistance there may be corrosion or bad wiring between the solenoid and PCM/ECM.
Control solenoid - With the electrical harness to the solenoid unplugged, using the DVOM set to ohms, check for resistance between each of the electrical terminals on the control solenoid itself. Use the factory specifications or a known good control solenoid if available to determine if there is excessive resistance in the solenoid. If there is an over limit or excessive resistance reading on the DVOM, the solenoid is likely faulty. Check for a short to ground through the control solenoid by putting either DVOM lead to a known good ground and the other to each terminal on the control solenoid. If there is resistance present, the solenoid may be shorted internally.
Short to power - Unplug the harness to the PCM/ECM and locate the wires to the control solenoid. With the DVOM set to the volts scale, connect the negative lead to ground and the positive lead to the wire(s) to the control solenoid. Check for voltage, if there voltage present there may be a short to power in the wiring harness. Locate the short to power by unplugging harness connectors and testing the wiring back to the solenoid.
Short to ground - Unplug the harness to the PCM/ECM and locate the wires to the control solenoid. With the DVOM set to the volts scale, connect the positive lead to a known good voltage source such as the battery and the negative lead to the wire(s) to the control solenoid. Check for voltage, if there is voltage present there may be a short to ground in the wiring harness. Locate the short to ground by unplugging harness connectors
Read: 49
