P0464 Fuel Level Sensor Circuit Intermittent Trouble Code

P0464 Fuel Level Sensor Circuit Intermittent

OBD-II Trouble Code Technical Description

Fuel Level Sensor Circuit Intermittent

What does that mean?

This generic powertrain/engine diagnostic trouble code typically applies to all OBDII equipped engines, but shows up more often in certain Hyundai, Infiniti, Isuzu, Kia, Mazda, Mercedes Benz, Nissan and Subaru vehicles.

The Fuel Level Sensor (FLS) is usually found mounted in the fuel tank, usually in the top of the fuel tank / fuel pump module. The FLS converts the mechanical fuel level into an electrical signal for the Powertrain Control Module (PCM). Typically, the PCM will then inform other controllers utilizing the vehicle’s data communication bus.

 

The PCM receives this voltage signal to determine how much fuel it has in the fuel tank, monitoring fuel usage and thereby determining fuel economy. This code is set if this input does not match normal operating voltages stored in the PCM’s memory, even for a second, as this diagnostic trouble code demonstrates. It also looks at the voltage signal from the FLS sensor to determine if it is correct at initial Key On.

P0464 could have been set because of mechanical (incorrect fuel level rationality; refueling the vehicle with the ignition switch "on" or even engine running can do this. Fuel level changes too rapidly which is not normal) or electrical (FLS sensor circuit) issues. These cannot be overlooked in the troubleshooting stage, especially when dealing with an intermittent problem.

Troubleshooting steps may vary depending upon manufacturer, type of FLS sensor and wire colors.

Related fuel level sensor circuit trouble codes include:

P0460 Fuel Level Sensor Circuit Malfunction P0461 Fuel Level Sensor Circuit Range/Performance P0462 Fuel Level Sensor Circuit Low Input P0463 Fuel Level Sensor Circuit High Input

Severity & Symptoms

Severity depends upon the failure. If a mechanical failure; severe. If an electrical failure, not as severe, as the PCM can compensate for it. The compensation usually means that the fuel gauge reads Empty or Full all the time.

Symptoms of a P0464 engine code may include:

Malfunction Indicator Lamp (MIL) illuminated Decrease in perceived fuel economy Decrease in Distance to Empty mileage Incorrect fuel level on gauge in instrument cluster – always reads wrong

Potential Causes

Typically the causes for this code to set are:

Intermittent open in the signal circuit to the FLS sensor - possible Intermittent short to voltage in the signal circuit to the FLS sensor- possible Intermittent short to ground in the signal circuit to the FLS sensor- possible Failed FLS Sensor / sensing arm stuck mechanically - likely Failed PCM - unlikely

Diagnostic and Repair Procedures

A good starting point is always a technical service bulletin (TSB) search for your particular vehicle. The vehicle manufacturer may have a PCM flash/reprogram to cover this issue, and it pays to check on this before you find you’ve gone down a long/wrong path.

Next, locate the Fuel Level Sensor (FLS) on your particular vehicle. This sensor is usually found mounted in the fuel tank or possibly even in the top of the fuel tank / fuel pump module. Once located, visually inspect the connector and wiring. Look for scraping, rubbing, bare wires, burn spots or melted plastic. Pull the connector apart and carefully inspect the terminals (the metal parts) inside the connector. See if they look burned or have a green tint indicating corrosion. Use electrical contact cleaner and a plastic bristle brush if cleaning of the terminals is needed. Let dry and apply electrical grease where the terminals contact.

If you have a scan tool, clear the diagnostic trouble codes from memory, and see if P0464 code returns. If it does not, then the connections were most likely your problem.

<

_{Read: 45}