P210B Throttle Actuator "B" Control Motor Circuit Range/Performance Trouble Code

P210B Throttle Actuator B Control Motor Circuit Range Performance

OBD-II Trouble Code Technical Description

Throttle Actuator B Control Motor Circuit Range Performance

What does that mean?

This generic powertrain/engine diagnostic trouble code typically applies to all OBDII equipped engines with electric Throttle Actuators, but shows up more often in certain Ford and Nissan vehicles.

The Throttle Actuator B (TA-B) is can usually be found mounted to the front of the engine, on top of the engine, inside the wheel wells or against the bulkhead. The TA-B is operated by an electrical signal from the Powertrain Control Module (PCM).

 

The PCM receives inputs to determine when and how long it needs to operate the TA-B. These inputs are voltage signals received from coolant temp, intake air temp, engine rpm and air conditioning system pressure sensors. Once the PCM has received these inputs it can modify the signal to the TA-B.

P210B is typically set because of electrical (TA-B circuit) issues but can be caused by mechanical issues, such as a mechanically stuck throttle blade on the electrically driven Throttle Actuator. Both electrical and mechanical issues cannot be overlooked in the troubleshooting stage, especially when dealing with an intermittent problem.

Troubleshooting steps may vary depending upon manufacturer, type of TA-B and wire colors.

Related throttle actuator B control motor circuit codes:

P210A Throttle Actuator "B" Control Motor Circuit Open P210C Throttle Actuator "B" Control Motor Circuit Low P210D Throttle Actuator "B" Control Motor Circuit High

Code Severity & Symptoms

Severity is usually severe due to its impact on the cooling system. Because this can be either an electrical or mechanical failure, the PCM cannot fully compensate for it. Partial compensation usually means that the engine has a fixed idle speed (usually around 1000 – 1200 rpm).

Symptoms of a P210B engine code may include:

Malfunction Indicator Light On Fixed idle speed Unable to accelerate engine

Causes

Typically the causes for this code to set are:

Open or short in the circuit to the Throttle Actuator - likely Failed Throttle Actuator - inoperative (mechanically or electrically) - likely Failed PCM - unlikely

Diagnostic and Repair Procedures

A good starting point is always to check for technical service bulletins (TSB) for your particular vehicle. Your issue may be a known issue with a known fix put out by the manufacturer and can save you time and money during diagnosis.

Next, locate the Throttle Actuator B (TA-B) on your particular vehicle. This actuator is usually found mounted to the front of the engine, on top of the engine, inside the wheel wells or against the bulkhead. Once located, visually inspect the connector and wiring. Look for scraping, rubbing, bare wires, burn spots or melted plastic. Pull the connector apart and carefully inspect the terminals (the metal parts) inside the connector. See if they look burned or have a green tint indicating corrosion. Use electrical contact cleaner and a plastic bristle brush if cleaning of the terminals is needed. Let dry and apply electrical grease where the terminals contact.

If you have a scan tool, clear the diagnostic trouble codes from memory, and see if P210B code returns. If it does not, then the connections were most likely your problem.

For this particular code, this is the most common area of concern, as are the relays / connections to the relays, with an actuator failure a close second.

If the code does return, we will need to test the actuator and the associated circuits. Typically, there are 2 wires at each Throttle Actuator. First, disconnect the harness going to the Throttle Actuator. With a Digital Volt Ohm Meter (DVOM), connect one lead of the meter t

_{Read: 22}